• Verify Rep

Add Small Appliance Module to System

To add a lighting module to your system, complete the following steps:



SkyControl Users:


1On your panel, tap the menu icon in the bottom right (three horizontal lines).

  • For firmware 3.0 or later, the icon will be in the upper left.
2Tap Settings and enter your 4-digit PIN.
3Tap Installer Toolbox and enter the Installer Code.

  • If you are having issues getting into the installer toolbox, chat in for assistance.
4Tap Z-Wave then Add Node.

  • For firmware 3.0 or later, you will need to tap Smart Home Devices first.
5Walk to your module and press the button. For some models, you will need to triple click the button.

  • The module needs to be plugged in and within 25 feet of the panel.
6The panel should show Device Successfully Added. Tap Back and press the Home button.

  • For firmware 3.0 or later, here is where you can name your device then select Done.

If the module isn't showing on your panel after this, repeat step 5. It can take 2-3 minutes for the panel to download all the device settings.




Go!Control Users:


1On your panel, tap Services.
2Tap the wrench icon and enter the Installer Code.

  • If you are having issues getting into the installer toolbox, chat in for assistance.
3Select Add Device.
4Walk to your module and press the button. For some models, you will need to triple click the button.

  • The module needs to be plugged in and within 25 feet of the panel.
5The panel should show Device Successfully Added. Tap Back and press the Home button.

  • If the module isn't showing on your panel after this, repeat step 4. It can take 2-3 minutes for the panel to download all the device settings.

Did this answer your question?

For more help, chat or send us a message.

Call 855.898.8908